When I use it within Qemu it works pretty perfekt. (Slower, but works.)
Because USB within Qemu really sucks, I would have had assumed VMWare should be no problem at all.
If your schematic is correct than V-USB does implement all the necessary stuff to be enumerated correctly on any USB Host Controller.
(It even passes the tests in usb.org’s test utility.)
Because (during enumeration and during USBaspLoaders normal work) only the control endpoint is used, it should really be no problem to use it in VMWare.
Perhaps close all "outside VM" software using the device and try it again in VM.
What is your problem in detail? Does the VM enumerate the device? Can you perhaps post your VMs syslog after plug and unplugging the USBaspLoader?
What outputs "lsusb -vvvv" ?
Out of curiosity: What USBaspLoader do you use? The recent "https://github.com/baerwolf/USBaspLoader" one?
Best regards,
Because USB within Qemu really sucks, I would have had assumed VMWare should be no problem at all.
If your schematic is correct than V-USB does implement all the necessary stuff to be enumerated correctly on any USB Host Controller.
(It even passes the tests in usb.org’s test utility.)
Because (during enumeration and during USBaspLoaders normal work) only the control endpoint is used, it should really be no problem to use it in VMWare.
Perhaps close all "outside VM" software using the device and try it again in VM.
What is your problem in detail? Does the VM enumerate the device? Can you perhaps post your VMs syslog after plug and unplugging the USBaspLoader?
What outputs "lsusb -vvvv" ?
Out of curiosity: What USBaspLoader do you use? The recent "https://github.com/baerwolf/USBaspLoader" one?
Best regards,