It's still not working on my end. Since I am using INT0 (d+) and INT1 (-d) I was not able to write a custom IRS for INT0 (already used in usbdrv), but I was able to use IRS INT1 vector. But I have a trigger on INT1 even when powering my board from an external supply (USB not even connected).
Is this define somewhat important?
#define USB_CFG_IS_SELF_POWERED 0
/* Define this to 1 if the device has its own power supply. Set it to 0 if the
* device is powered from the USB bus.
Thanks for all the help so far guys!
(For the time being I will use a switch on an I/O)
Is this define somewhat important?
#define USB_CFG_IS_SELF_POWERED 0
/* Define this to 1 if the device has its own power supply. Set it to 0 if the
* device is powered from the USB bus.
Thanks for all the help so far guys!
(For the time being I will use a switch on an I/O)